Operation/installation/service manual MACERATOR TOILETS
Manuale di utilizzo / installazione / manutenzione TOILET MACERATRICI
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
www.thetfordmarine.com / TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
Manual rev 25.2014 ©TECMA SRL
2.5 Control panel with “SMART FLUSH” technology
2.5.1 Premium
Press the “BEFORE USE” button before using the toilet. This will fill the toilet with a small amount
of water. Press the “AFTER USE” button after using the toilet. This will start the automatic flush
cycle, after which the toilet will be emptied if the “marine” mode is enabled. Alternatively, a small
amount of water will remain in the toilet if the “mooring” mode is enabled.
To switch from mooring mode to marine mode, press and hold the two buttons at the same time
until the “LOCK OUT” LED starts blinking. This will change the mode.
The control panel is equipped with a 3-colour LED, which indicates the blackwater tank level. (Refer
to par. 3.5.
As soon as the maximum level is reached, the sensor disables the functions of the push-button
panel, preventing use of the toilet.
To force this block and enable the control panel, press both buttons at the same time twice. The
“LOCK OUT” LED turns on to indicate that the control unit is in lockout mode.
For detailed programming of the Premium control panel functions (Smartflush Technology) refer
to par. 2.5.3.1.
To Next Page
Loading...