Operation/installation/service manual MACERATOR TOILETS
Manuale di utilizzo / installazione / manutenzione TOILET MACERATRICI
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
www.thetfordmarine.com / TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
Manual rev 25.2014 ©TECMA SRL
Change flushing mode – from mooring mode to sailing mode (Fig.2)
If you have already adjusted the amount of water and now want to go back to sailing mode:
1) Press and hold the BEFORE USE and AFTER USE buttons for approximately 3 seconds. The
lock LED will flash, indicating that the programming mode is enabled.
2) Release both buttons when the desired water level has been reached
3) The system is now set to sailing mode
NOTE: at the end of the cycle, the toilet remains empty if the system is set in “sailing mode”.
Alternatively, a small amount of water remains in the toilet if the system is set in “mooring mode”.
Press and hold for about 3 sec
Lockout LED starts blinking
Keep pressing and holding for
about 4 sec
Water starts coming in
Keep pressing and holding the
buttons and release them when
the desired amount of water is in
the bowl
Release as soon as the lockout
LED starts blinking
Press and hold for about 3 sec
To Next Page
Loading...