Operation/installation/service manual MACERATOR TOILETS
Manuale di utilizzo / installazione / manutenzione TOILET MACERATRICI
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
- If the Toilet is connected to a sea cock, install a marine ball safety valve (activated by a
lever) in correspondence of the sea cock.
- If water fails to flow after the first two/three flushes, there may be an assembly problem
or malfunction. In this case, do not use the toilet and refer to the "Troubleshooting"
section.
- Only use stainless steel hardware. Always use the supplied ceramic-protection rubber
inserts. Any toilet assembly errors may result in improper movements, which may
damage objects or injure persons.
- The toilet is designed to dispose of human waste and toilet paper. Never flush other
types of materials (e.g. paper towel, wet wipes, condoms, sanitary pads, dental floss,
etc.)
- Always use the screw caps, ceramic-protection rubber inserts, and connectors supplied
with the toilet.
- If in doubt, please refer to your TECMA distributor.
WARNING: Flush toilet paper only.
3.1 Installation site
Before starting installation:
- make sure that the blackwater tank is in a suitable position and can be reached from the
toilet installation site
- make sure that the toilet configuration corresponds to the hydraulic and electric system
of the boat.
- make sure that the chosen model is suitable for the installation into, taking into
consideration:
the foot overall dimensions
correct seat cover opening
To Next Page
Loading...