10
in accordance with
Annex VI of Directive 2014/53/EU of the European Parliament
and of the Council
1.For the following Radio equipment:
Model: BD2
Product: Mobile Phone
Trade name or Brand: TECNO
Software / Hardware number: BD2-SP613ABC-QGo/V1.0
2. Name and address of the manufacturer or his authorised
representative:
Manufacturer: TECNO MOBILE LIMITED
Add: FLAT 39 8/F BLOCK D WAH LOK INDUSTRIAL CENTRE
31-35 SHAN MEI STREET FOTAN NT
3. This declaration of conformity is issued under the sole
responsibility of the Manufacturer.
4. Object of the declaration (identification of the radio
equipment allowing traceability; it may include a colour image of
sufficient clarity where necessary for the identification of the
radio equipment):
5. The object of the declaration described above is in
conformity with the relevant Union harmonization legislation:
Directive 2014/53/EU (RED)
6. References to the relevant harmonised standards used or
references to the other technical specifications in relation to
which conformity is declared:
Article 3.1a Health: EN 50360:2017
EN 50566:2017
EN 62479:2010
EN 62209-1:2016
EN 62209-2:2010
Article 3.1a Electrical Safety: EN62368-1:2014+A11:2017
Article 3.1b: ETSI EN 301 489-1 V2.2.3 (2019-11)
ETSI EN 301 489-17 V3.2.4 (2020-09)
ETSI EN 301 489-19 V2.1.1 (2019-04)
Draft ETSI EN 301 489-52 V1.1.2 (2020-12)
EN55032:2015
EN55035:2017
EN61000-3-2:2014
EN61000-3-3:2013
Article 3.2: ETSI EN 301 511 V12.5.1 (2017-03)
ETSI EN 301 908-1 V13.1.1 (2019-11)
ETSI EN 301 908-2 V13.1.1 (2020-06)
ETSI EN 300 328 V2.2.2 (2019-07)
ETSI EN 303 345-1 V1.1.1 (2019-06)
Draft ETSI EN 303 345-3 V1.1.0 (2019-11)
ETSI EN 303 413 V1.1.1 (2017-06)
7. Notified Body Name: Eurofins MET Laboratories, Inc.
Notified Body Number: 0980
Notified Body Assessment Performed: Module B/C on Article
3.1a, 3.1b, 3.2
Technical File Identification Number: N/A
8. Where applicable, description of accessories and
components, including software, which allow the radio
equipment to operate as intended and covered by the EU
declaration of conformity: User instructions are provided in
the User Manual. The Software and Hardware versions are
specified above.
9. Additional information:
Referring to Article 10.2 of the Directive, this equipment is so
constructed that it can be operated in all Member States,
without infringing applicable requirements on the use of radio
spectrum.
Referring to Article 10.10 of the Directive, there are no
restrictions on putting this equipment intoservice or of
requirements for authorisation of use. Please refer to the
User Manual for details.
On behalf of:
Manufacturer: TECNO MOBILE LIMITED
Add: FLAT 39 8/F BLOCK D WAH LOK INDUSTRIAL
CENTRE 31-35 SHAN MEI STREET FOTAN NT
(place and date of issue): Shenzhen, 2021-01-25
(name, function): Yiting Luo/ Manager
(signature):
To Next Page
Loading...
