TECNOEKA KF 981 - Technical Specifications

_ Electric Oven _ rev. 0 ___________________________________________________________ KF 981 – KF 981 UD_
_________________________________________________________________________________________ page 7 _
3. Technical specifications
height (feet included) cm
78
width cm 91
Overall dimensions:
depth cm 75
Weight: kg 86
height cm 51.5
width cm 60
Internal dimensions
(effective) of the cooking
compartment:
depth cm 45
Volume (effective): dm
3
139
Tray maximal load: GN 1/1 kg 4
Total load: 6 trays GN 1/1 kg 24
2 Convection heating elements kW 8
Power elements:
2 Convection motor ventilators W 240
Maximum total power: kW 8.4
Class: I (against electric shocks)
Degree of protection
against humidity:
IPX0
Power supply voltage: (50 Hz)
220/230V∼ 380/400V∼ 2N
Power cable diameter: 3 x 6 mm
2
4 x 2.5 mm
2
Type: H07RN-F H07RN-F
The noise level of the appliance in operation is below 70 dB (A).
The "technical data" plate is positioned on the rear panel of the appliance.
4. Instructions for the installer
The following instructions are aimed at the qualified installer, to ensure that he carries out
the installation, adjustment and maintenance operations as correctly as possible and according
to current legal regulations. Any operation must be performed with electrical power cut to the
appliance.
Before using the appliance, carefully remove the special adhesive film protecting the parts in
stainless steel. Do not leave any glue residues on the surfaces. If necessary, remove them at
once, with an appropriate solvent.
Positioning
- Position the appliance perfectly horizontally on a table or similar support (the
table or support must be at least 85 cm above the floor). Position it at a distance of not less
than 10 cm from the side and rear walls, to enable natural ventilating air to circulate freely
around it. The appliance is ventilated through specific openings on the metal walls of the outer
housing , and ensures efficiency and long-life. For this reason it is strictly forbidden to obstruct
these ventilation openings, even partially or for short periods. Failure to observe this specific
prohibition releases the manufacturer of the appliance from all responsibility and immediately
voids any guarantee rights for the said appliance, because its constructive conformity has been
voluntarily compromised. Furthermore, the appliance is not suitable for embedding and for
grouped positioning with other identical appliances.
Electrical connection
- The appliance must be connected to the electrical mains according to
current legal regulations. Before making the connection, make sure of the following:
- the voltage and frequency values of the power supply system match the values on the
"technical data" plate affixed on the appliance;
- the limiting valve and the system are able to support the appliance's load (see the
"technical data" plate);
- the power supply system has an adequate earth connection according to current legal
regulations;