5
1 – Possible problems during installation.
1.1 – Pump loading manual phase relation.
If the machine is left without working for a long time, the soft rubber (made of food grade
silicone) may stay stuck in its seat.
To solve this problem, first fill the tank as shown in the manual, put the plug into the power
socket, press the main switch (1) (see fig. 1), press the button (4) to make sure that it is
impossible to load the pump, then try a manual operation as follows:
fig.1
1 – Lift the top lid of the device (see fig. 2).
fig.2
2 – Take the suction pipe out of the tank and inject water into the suction pipe, also using a syringe, while
keeping the button (4) pressed (see fig.3)
fig.3
3 – If you are unable to release the pump, you must replace it.
To Next Page