Chapter 4 Software index
4-32
C41 Local /Remote control select description
• Local mode
Run command
The Run/Stop pad on the keypad controls inverter F04 setting has no effect on control.
Frequency command
When C41=000: the UP/DOWN pad on the keypad controls the drive and the F05 setting has
no effect.
When C41=001: the potentiometer on the keypad controls frequency, and F05 setting has no
effect.
• Remote mode
Run command is by the run parameter (F04) setting
Frequency command from the frequency parameter (F05) setting
• Control select mode is changed by simultaneously pressing V/RESET and DATA/ENT keys
(Drive must be in stop mode)
Refer to F11~F14
1.) If the C44 scan time is set to 80 ms as an example (i.e N=10) then digital input signals on for less
than 80 msec will be ignored.
2.) If the scan signal is seen for N times (scan times), the inverter takes it as signal change. If it is seen
for less than N times, it is seed as noise. One scan time: 8ms.
3.) User can set scan interval time according to noise in the operation environment. Extend C44/C45 if
noise is a problem, however this will reduce the scan response time.
C42/43 (option card)
S5/S6 terminal on MFIT Setting
000: Forward
001: Reverse
002: Preset speed command 1
003: Preset speed command 2
004: Preset speed command 3
005: Jog Frequency Command
006: Emergency Stop (E.S.)
007: Base Block (b.b.)
008: Switching to 2
nd
acceleration/ deceleration time.
009: Reset
010: Up Command
011: Down Command
012: Control signal switch
013: Communication control signal switch
014: Acceleration/ deceleration disable
015: Master/ auxiliary speed switch
016: PID function disable
C44: Multi-function input terminal S1~S6 signal scan time (N. msec ×8), N = (1~100 times).
C45: AIN signal scan time (N. msec ×8), N = (1~100 times).
To Next Page
Loading...
