Why does the TECO Controller motor speed vary unusually?
If the TECO Controller motor speed varies unusually, it might be due to an excessive or erratic load. Try reducing the load or minimizing its variation. For erratic input power or phase loss, add an AC reactor at the power input side, especially if using single-phase power. If using three-phase power, check the wiring.
How to fix TECO Controller if motor runs in wrong direction?
If the TECO Controller motor is running in the wrong direction, ensure the wiring matches the U, V, and W terminals of the motor. Double-check all wiring to confirm it is correct.
What to do if TECO Controller motor can not run?
If the TECO Controller motor cannot run, first check if power is applied to the terminals and if the charging indicator is lit. If not, ensure the power is applied, turn the power off and then on again, verify the power voltage is correct, and make sure all screws are secured firmly. Also check for voltage across the output terminals U, V, and W by turning the power off and on again. Reduce the load to prevent motor stall due to overload. Check for abnormalities in the inverter by referring to error descriptions to correct the wiring if necessary. You can also try operating the controller through the digital keypad.
What to do if the TECO Controller motor speed can not be regulated?
If the motor speed of your TECO Controller cannot be regulated, ensure that the wiring is correct and check the operation mode of the operator. If the load is too excessive, reduce it.
General| Brand | TECO |
|---|---|
| Model | S310+ Series |
| Category | Controller |
| Language | English |
Guidelines for the electrical installation of the inverter and its components.
Shows the main circuit and control circuit wiring diagram for the S310+ inverter.
Detailed description of the main circuit and control circuit terminals on the S310+ inverter.
Detailed table of error codes, their causes, and suggested corrective actions.
A flowchart-based guide for quickly diagnosing and resolving inverter faults.
To Next Page
