Need help?Do you have a question about the TECO E310 Series and is the answer not in the manual?
General| Series | E310 |
|---|---|
| Frequency | 50/60 Hz |
| Control Method | PWM Control |
| Operating Temperature | -10°C to 50°C |
| Output Voltage | 0~Input Voltage |
| Control Mode | V/F control, Sensorless Vector Control |
| Communication Interface | RS-485 |
| Protection Features | Overvoltage, Overload |
| Storage Temperature | -20°C to 60°C |
| Humidity | 20% to 90% RH (Non-condensing) |
| Altitude | Up to 1000m |
General introduction and safety symbols for inverter operation.
Steps to check for damage and model accuracy upon receiving the inverter.
Safety guidelines for handling and installing the inverter.
Crucial safety steps before initial power application.
Critical procedures during the power-up sequence.
Essential checks before commencing inverter operation.
Guidelines to follow while the inverter is running.
Precautions to take when performing maintenance.
Explains how to interpret the E310 model numbers.
Specifies temperature, humidity, and other environmental factors.
Guidance on proper panel and enclosure arrangements.
Illustrates environments that can damage the inverter.
Covers wiring, terminals, fuses, and peripheral device installation.
Details technical specifications for different models.
Visual guides for connections and terminal functions.
Physical dimensions and mounting information.
Explanation of the digital keypad layout and basic usage.
Guide to choosing between V/F and Vector control modes.
Details on control mode, frequency limits, and acceleration/deceleration.
Configuration of multifunction digital input terminals for control.
Configuration of output relay operation modes based on inverter status.
Configuration of analog signal inputs and voltage/current outputs.
Settings for multiple preset speeds and their associated timing.
Configuration of start/stop methods and power loss handling.
Configuration of V/F curves and voltage/frequency ratios.
Settings for motor rated voltage, current, power, speed, and frequency.
Configuration of various protection mechanisms like overload and over-voltage.
Configuration for communication protocols and station numbers.
Configuration of PID control loops and feedback.
Settings for carrier frequency, S-curve, and skip frequencies.
Customization options for the inverter's display.
Settings for drive horsepower, software version, and parameter locking.
Configuration of automated sequences for running and stopping.
Identifies common fault codes and their solutions.
Faults requiring professional service or component replacement.
Faults that can be reset by user actions.
Describes specific states like STP1, STP2, E.S.
Lists errors related to parameter access and keypad operations.
Step-by-step guide for diagnosing common motor and speed regulation issues.
Visual guide for diagnosing inverter faults.
Specific flowchart for over-current and overload faults.
Specific flowchart for over-voltage and under-voltage faults.
Flowchart for diagnosing motor startup issues.
Guide for diagnosing motor overheating issues.
Guide for diagnosing uneven motor operation.
Checklist for regular inverter maintenance and checks.
Procedures for cleaning, tightening, and performing insulation tests.
Details on AC and DC reactor specifications.
Information on choosing and using braking components.
Instructions for connecting the digital keypad.
Dimensional drawings for keypad mounting.
Comprehensive table of inverter parameters and their default/recommended settings.
Contact information for TECO Electric & Machinery Co., Ltd.
Disclaimer regarding manual modifications.
To Next Page
