EasyManuals Logo

TECO JSDEP-30A Simplified Manual

TECO JSDEP-30A
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
39
Communication
Address
Parameter
Name & Function Default
Unit
Setting
Range
Control
Mode
RS232
RS485
Current offset automatic adjust (only used in
servo off)
Setting
Explanation
Cn053
1
Drive executes current offset adjust and
then clears setting to 0 automatically
when the adjustment is finished.
0 x
0
1
ALL C91H
0035H
Drive warning setting
Cn054
Parameter Cn054 set by hex code, and each bit
represents for each alarm. Setting the
corresponding bit to 1 for the alarm is a warn
mode. Drive warns and then triggers alarm after
continuously executing the setting time of Cn055
when alarm occurs.
Ex: Set Cn054 to 0801H, and then set Cn055 to
100 when low voltage or overspeed alarm is a
warn, which triggers alarm one second later.
0000100000000001 is the setting status,
presenting in binary.
0000 x
0000
FFFF
ALL C8DH
0036H
Drive warning delays the time of triggering
alarm
Cn055
Parameter Cn054 set by hex code, and each bit
represents for each alarm. Setting the
corresponding bit to 1 for the alarm is an warn
mode. Drive warns and then triggers alarm after
continuously executing the setting time of Cn055
when alarm occurs.
Ex: Set Cn054 to 0801H, and then set Cn055 to
100 when low voltage or overspeed alarm is a
warn, which triggers alarm one second later.
0000100000000001 is the setting status,
presenting in binary.
0
x10
msec
0
300
ALL C8EH
0037H

Table of Contents

Other manuals for TECO JSDEP-30A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TECO JSDEP-30A and is the answer not in the manual?

TECO JSDEP-30A Specifications

General IconGeneral
BrandTECO
ModelJSDEP-30A
CategoryServo Drives
LanguageEnglish

Related product manuals