What to do if TECO Servo Drives shows CPU error?
If your TECO Servo Drive displays a CPU Error, it indicates a control system malfunction. Turn off the power and turn it on again after 30 minutes. If the error alarm persists, it may be due to external interference.
General| Model | JSDEP-50A |
|---|---|
| Series | JSDEP |
| Manufacturer | TECO |
| Category | Servo Drives |
| Input Frequency | 50/60 Hz |
| Input Voltage | 200-240 VAC |
| Input Phase | Single-phase |
| Control Mode | Torque/Speed/Position |
| Communication Interface | RS-485 |
| Protection Features | Overcurrent, Overvoltage, Overheating |
| Operating Temperature | 0°C to 55°C |
| Storage Temperature | -20°C to 85°C |
| Humidity | 90% RH max (non-condensing) |
| Vibration Resistance | 5.9 m/s² (10-55 Hz) |
To Next Page
