REMOTE CONTROL & FUNCTIONS
SELF-CLEAN function
1. This function helps carry away the accumulated
dirt, bacteria, etc from the indoor evaporator.
2. This function will run about 30 minutes, and it
will return to the pre-setting mode. You can
press button to cancel this function during
the process.
You will hear 2 beeps when it's finished or
cancelled.
It's normal if there is some noise during this
function process, as plastic materials expand
with heat and contract with cold.
Indoor unit
Outdoor unit
oo
Temp < 86 F (30 C)
oo o o
41 F (5 C) < Temp < 86 F (30 C)
We suggest operating this function at the
following ambient conditions to avoid certain
safety protection features.
It's suggested to utilize this function every
3 months.
Only optional for some heating pump inverter
appliance.
To active this function, turn off the indoor unit
at first, then press CLEAN button
then you will hear a beep, AC will
appear on the indoor LED, and will
appear on the remote display .
ANTI-MILDEW function
Press button to activate the ANTI-MILDEW
function, will appear on the display. Do it again
to deactivate this function. After running COOL/
DRY for more than 30 minutes, you can operate
this function, the unit will blow airflow for about
15 minutes to dry the inner parts to avoid mildew,
then shuts off the unit.
Note: ANTI-MILDEW function only available in
DRY/COOLING mode.
ANTI-
MILDEW
ANTI-
MILDEW
10
To Next Page
Loading...
