Tecomat TC600
TXV 138 08.02 64
INITAB - address of the table containing the initialization data
Parameter is entered symbolically, for example IniCH2, or
absolutely, for example T0 (names used in the following ex-
amples of declarations are not mandatory).
Entering of the parameter for CH2, CH3, analog inputs and
some special functions (see further) is mandatory. The pa-
rameter is not entered for binary inputs and outputs.
Another possibility of the sw configuration is declaration of the PLC spe-
cial functions. Special function use standard-fitted PLC inputs and outputs,
however their servicing requires more complicated shell algorithms or com-
plementation of the basic technical equipment of the input and output unit.
These servicing algorithms are realized by the system, thus servicing by the
user program remains simple.
The xPRO program contains the function for automatic generation of sw
configuration according to the connected PLC type and its further editing.
This enables the user to have the sw configuration created exactly accord-
ing the real technical equipment or create a basis for the user's own decla-
ration of inputs, outputs, and functions of the PLC set.
If no sw configuration is entered in the user program, the program will be
solved only above the PLC scratchpad memory and the PLC inputs and
outputs will not be serviced. Binary outputs will remain blocked in this case
and analog outputs will remain set to zero.
Declaration of special
functions
Automatic generation
of the sw
configuration
Solving of the user
program with
disconnected inputs
and outputs
To Next Page