Why is the displayed instant pressure inaccurate on my Tecomec GEOline GEOSYsTEM 240?
The displayed instant pressure might be inaccurate because of incorrect programming. Check the full scale programming for the pressure sensor. Also, the pressure sensor may not have been calibrated, so perform the calibration. Another possible reason is an incorrect installation of the pressure sensor, so check the connections.
What to do if the counting of the distance traveled shown on the Tecomec Geosystem Farm Equipment is different from the actual distance?
If the distance shown on the Geosystem is different from the actual distance, it could be due to incorrect programming. Check the connection with the speed sensor. Another reason might be that the totalizer has not been reset; in this case, reset the totalizer.
What to do if the counting of the treated area shown on the Tecomec Geosystem Farm Equipment is different from the actual area?
If the treated area shown on the Geosystem is different from the actual area, it may be due to incorrect programming. Check the boom width programming. Alternatively, the totalizer may not have been reset; if so, reset the totalizer.
Why is the displayed tank level inaccurate on my Tecomec GEOline GEOSYsTEM 240?
The displayed tank level may be inaccurate because the level sensor has not been calibrated. Perform the calibration and repeat the level sensor calibration. It could also be due to incorrect installation of the level sensor, so check the connection with the level sensor.
Why is the instant pressure not shown on my Tecomec Farm Equipment?
The instant pressure might not be displayed because the monitor is not receiving a signal from the pressure sensor. Check the connections with the pressure sensor. It could also be due to incorrect installation of the pressure sensor; check the connections with the pressure sensor in this case as well.
How to fix a display that does not turn on for Tecomec GEOline GEOSYsTEM 240?
If the display does not turn on, it could be due to a lack of power. Check the power cable connections. Alternatively, the monitor may be turned off, so press the ON button.
What to do if a valve does not open on Tecomec Farm Equipment?
If a valve does not open, it may be because there is no power going to the valve. Check the electric connection and the functioning of the valve.
Why the valves cannot be controlled on Tecomec GEOline GEOSYsTEM 240 Farm Equipment?
If the valves cannot be controlled, a possible cause is that the valves are not connected. In this case, connect the connectors.
Details about the GeoSystem monitor configurations for Orchard Sprayer (OS) and Crop Sprayer (CS).
Diagrams showing the connection for Crop Sprayer (CS) and Orchard Sprayer (OS) versions.
Procedure for connecting the GPS antenna to the GeoSystem monitor.
Guidelines for positioning and installing the speed sensor.
Details the function of each key and switch on the CS monitor.
Setting general parameters required for the monitor's correct operation.
Details the function of each key and switch on the OS monitor.
Setting general parameters required for the monitor's correct operation.
How the monitor acquires measurements and performs adjustments during operation.
Procedures for nozzle, tank level, and speed sensor calibration.
Explanation of the display layout for the Crop Sprayer (CS) version.
Definition of 'treatment' and how data is stored and managed.
Steps to start recording data for a new treatment.
Information on warnings, alarms, and how they are indicated.
A list of potential alarms and their causes.
Procedure to check the functionality of the GPS antenna and receiver.
Example installation for a 5W CS system on a 4-section sprayer.
Example installation for a 4OS system on a 2-section sprayer.
Steps to start data recording for a new treatment.
Procedure for refilling the tank and modifying the quantity.
How to view the list of the last 20 treatments.
General| Brand | Tecomec |
|---|---|
| Model | GEOline GEOSYsTEM 240 |
| Category | Farm Equipment |
| Language | English |
To Next Page