English version
4. OPERATION GUIDE
Begin Programming
Record Enable
1. Press and hold down the Record button.
2. While holding down the Record button, tap the
Flash buttons 1, 6, 6 and 8 in sequence.
3. Release the Record button, the Record LED
lights up, now you can begin programming your
chase patterns.
Note: The rst time you turn on your unit, the
default setting of the Record Code is Flash buttons
1, 6, 6 and 8. You may change the Record Code to
protect your programs.
Rear View
35. Power Switch - This switch controls turning on
or o of the power.
36. DC Input - DC 12-20V, 500 mA Min.
37. MIDI Thru/Out/In - MIDI ports for connection to
a sequencer or MIDI device.
38. DMX Out - This connector sends your DMX value
to the DMX xture or DMX pack.
39. Audio Input - This jack accepts a line level au-
dio input signal ranged from 100mV to 1Vpp.
40. Remote Input - Black Out and Full On may be
controlled by a remote control using a standard
1/4"stereo jack.
41. Fog Machine Connector
35 36 37 38 39 40 41
To Next Page
Loading...
Need help?
General
