Need help?Do you have a question about the TECshow NAVIGATOR 24 XL and is the answer not in the manual?
General| Brand | TECshow |
|---|---|
| Model | NAVIGATOR 24 XL |
| Category | Controller |
| Language | English |
Details on interface, connectors, physical attributes, and features of the Navigator 24XL.
Details the buttons and faders on the front of the Navigator 24XL.
Details the ports and switches located on the rear of the device.
Explains how to re-assign physical faders to control different DMX channels.
Describes how to switch between control pages for channels 1-24 and 25-48.
Steps to enable the recording mode for programming scenes and effects.
Guide on composing and saving a static lighting state or a multi-step scene.
Instructions on how to delete a specific program or scene from the controller.
Procedure to reset the controller by erasing all stored scenes.
How to clear temporary memory, including scenes not yet assigned to faders.
Steps to enter the editing mode for modifying existing scenes or programs.
How to remove individual steps from a programmed scene.
How to add new steps into an existing scene.
Instructions on how to adjust intensity or other attributes of steps within a scene.
How to trigger scenes using audio input or the built-in microphone.
Using the speed slider to control the playback speed of scenes.
How to synchronize scene playback with a standard beat or tempo.
How to assign and use auxiliary controls for shortcuts like DMX strobe or fog machines.
How to configure the controller to receive MIDI commands.
How to configure the controller to transmit MIDI commands.
Process for copying shows from another Navigator 24XL via MIDI.
To Next Page
