Tecsis Manoport E3905 User Manual

Betriebsanleitung/Operating manual
E3905 / P3394
32 BD_BE 763 b www.tecsis.de
Menu
PARAM.
Setting
Meaning
Set
Conf
Set Configuration: General configurations
Unit**
mbar, bar
Unit: Unit of display
SL**
OFF / ON
Sea-level correction: on or off
(Alti) -2000..9999
(only if SL is on)
Altitude: Input of altitude above sea level in [m]
rAtE**
Rate: measuring rate
Slo
Slow measuring rate
(4Hz filtered, low power consumption)
FASt
Fast: measuring rate, filtered (>100Hz)
P.dEt
Peak detection :fast measuring rate,
unfiltered (>100 Hz)
P.OFF
1..120
Auto Power-Off time in minutes
OFF
Auto Power-Off deactivated
Adr.
01,11..91
Base address of interface
Set
AL.
Set Alarm: Settings of alarm function
AL.
[1,2,DIF]
ON
Alarm on, with horn-sound
no. So
Alarm on, without horn-sound
OFF
No alarm function
(AL.Lo)
[1,2,DIF]
SensorMin
... AL.Hi
(not if AL.oFF)
Min-alarm-limit
(AL.Hi)
[1,2,DIF]
AL.Lo ...
SensorMax
( AL. oFF)
Max-alarm-limit
Set **
LOGG
Set Logger: Settings of logger function
Func
CYCL
Cyclic: logger function „ cyclic logger“
STOR
Store: logger function, „individual value logger“
OFF
No logger function
(CYCL) 1..3600
(only if Func CYCL is set)
Cycle time of cyclic logger in [seconds]
(Lo.Po) ON / OFF
(only if cyclic logger and slow measuring rate is
set)
Low-Power-Logger with very low power
consumption
Set
CLOC
Set Clock: Settings of real time clock
CLOC
HH:MM
Clock: Setting of time: hour : minutes
YEAr
YYYY
Year: Setting of time: year
dAtE
TT.MM
Date: Setting of time: day : month
Please note: If the logger memory contains data already, the menus/parameters marked with (**)
can not be invoked! If these should be altered the logger memory has to be cleared
before (p.r.t. chapter 6)!

Tecsis Manoport E3905 Specifications

General

Brand	Tecsis
Model	Manoport E3905
Category	Measuring Instruments
Language	English