AUTO-TUNING STORAGE (ATS)
FOR AM
Enter VF mode
Press and hold the AM button for 1 second.
PRESET will flash and the radio runs through the band storing all available stations into memory.
When storage is complete, the radio will begin broadcasting the first stored station.
Rotating the course tuning dial will play each stored station as the dial is turned.
FOR FM
Perform the same steps as you did for AM.
With two exceptions: fully extend the telescopic antenna and press and hold the FM button for 1 second.
FOR SW
Perform the same steps as you did for FM.
With two exceptions: fully extend the telescopic antenna and press and hold the SW button for 1 second.
Now choose whether to store all available frequencies within all meter bands or within a chosen meter band.
Press and hold the down-arrowhead button to run through all available stations within all meter bands.
Press and hold the up-arrowhead button to run through all available station within a given meter band.
MEMORY PAGE SELECTION
This allows you to chose what page and the location a station in memory is stored.
Press FM, AM, or SW button for band selection.
Tune to a desired station.
Press the MEMORY button, the memory address flashes in upper right corner of display panel.
Go to the PAGE buttons.
Press the + to advance up in page number.
Press the – to advance down in page number.
Rotate the course tuning dial to choose your desired memory address location.
Press the MEMORY button or wait 3 seconds for the new location of the memory address to be stored.
LISTENING TO STORED STATIONS
MANUALLY BROWSE STORED STATIONS
Press FM, AM, or SW button for band selection.
Press VF/VM button to enter VM mode.
Go to the PAGE buttons.
Press the + to advance up in page number.
Press the – to advance down in page number.
Rotate course tuning dial to tune to a desired station within a memory page.
AUTO BROWSE (SEMI-AUTO) STORED STATIONS
Press FM, AM, or SW button for band selection.
Press VF/VM button to enter VM mode.
Press and hold the VF/VM button until PRESET flashes in the upper right corner of the display panel.
Go to the PAGE buttons.
Press the + to advance up in page number.
Press the – to advance down in page number.
Rotate course tuning dial to tune to a desired station within a memory page.
The radio will auto browse all stored stations in a selected page, staying on each for 5 seconds.
Stop auto browsing by pressing VF/VM button or rotating course tuning dial.
To Next Page
Loading...
Need help?
General
