Tecsun PL880 - BANDWIDTH SELECTION WHILE LISTENING; DELETING STORED RADIO STATIONS; MANUALLY DELETE SINGLE STATION; AUTO BROWSE DELETE STATIONS

DIRECT ENTRY OF STORED STATIONS
I will not cover this. Why? A person would need to remember the exact page and location of where each station is
stored in memory. It is easier to AUTO BROWSE stored stations.
BANDWIDTH SELECTION WHILE LISTENING
While listening on AM or SW, press the AM BW button.
Press the AM BW button repeatedly to cycle through the options: 9, 5, 3.5 or 2.3 kHz of AM bandwidth.
Stop pushing the AM BW button when your selection appears in the display.
While listening on SW, choose either USB or LSB. USB or LSB will be displayed above the frequency.
CORAC’s communications occur on USB of SW.
Press the AM BW button repeatedly to cycle through the options: 4, 3, 2.3, 1.2, or 0.5 kHz of AM bandwidth.
Stop pushing the AM BW button when your selection appears in the display.
Select a higher number to widen the bandwidth when receiving strong signals or local stations.
Select a lower number to narrow the bandwidth for weak signals or long-distance stations. Doing so will limit
interference and reduce background noise.
DELETING STORED STATIONS
This function ONLY WORKS IF the delete button is pressed within 3 seconds. Otherwise, this function is exited with no
changes saved.
MANUALLY DELETING A SINGLE STATION
Rotate the course tuning dial to a stored station in memory.
Press the DELETE button and release.
PRESET and DEL will flash in upper right corner of display panel.
Press the DELETE button again to remove the unwanted memory address.
AUTO BROWSE (SEMI-AUTO) DELETING A STORED STATION
Enter VM mode
Press and hold the VF/VM button.
PRESET will flash and the radio will cycle through stored stations pausing for 5 seconds on each station.
Press the DELETE button to remove unwanted stations in memory.
Press and hold the VF/VM button to continue the process.
If finished with the process, simply do not push the VF/VM button to stop.
MANUALLY DELETING ALL STATIONS WITHIN A PAGE
Enter VM mode
Press and hold the DELETE button for 3 seconds
DEL and page number in upper right corner of display panel will flash.
Note which page of stored memories you are on.
Go to the PAGE buttons.
Press the + to advance up in page number.
Press the – to advance down in page number.
Press DELETE button once more to delete all stored stations within a selected page.
If the DELETE button is not pressed within 3 seconds for confirmation, the delete function exits automatically.