Tecumseh Argus - Start up Information

32
©2019 Tecumseh Compressor Company LLC. All rights reserved. TPC Part #71511 | Rev A 05/13/2019www.tecumseh.com
Compressor discharge pressure: _____________ psig Compressor suction pressure: _____________ psig
Discharge line temperature at compressor _________ ºF _________ ºC
Suction line temperature at compressor _________ ºF _________ ºC
Superheat at compressor : _________ ºF _________ ºC Superheat at evaporator : _________ ºF _________ ºC
Suction line temperature at evaporator TX valve bulb: _________ ºF _________ ºC
Project Name:
Address of Installation:
Installing Contractor Name:
Address:
Phone:
IMPORTANT: This start-up information should be
completely filled in for each installation and remain with
the unit as a permanent record for future reference.
Type of System (Cooler, Freezer, etc…):
Design Box Temperature: _________ ºF _________
ºC
Thermostat setting : _________ ºF _________ ºC
Unit model #: Evaporator(s) Manufacturer:
Unit serial #: Evaporator(s) QTY:
Compressor model #: Expansion valve - Manufacturer:
Compressor serial #: Expansion Valve Model #:
Leak Check Procedure:
Unit leak check by:
Company: Date:
Refrigerant Type: Total Charge:
Ambient at start-up: _________ ºF _________ ºC Operating box temperature: _________ ºF _________ ºC
Defrost settings: / day Minutes fail safe:
Condensing unit electrical rating: Volts: Phase : Hz:
Voltage at compressor terminals: L1: L2: L3:
L1/L3Amperage at compressor: L1: L2: L3:
Start-up Information