Page 4 Four-Cycle L-Head Engine • Vertical Crankshaft • Air-Cooled 181-732-14
B. Fuel
Use unleaded regular, unleaded premium or reformulated
automotive fuel only. You may use gasoline containing the
following components identified in Table 2.
• DO NOT use leaded fuel.
• Fuel must be fresh and clean. NEVER use fuel left
over from last season or stored for long periods.
• NEVER mix oil with fuel.
• DO NOT use fuel containing Methanol (Wood
Alcohol).
IV. Before Starting Your Engine
A. Checking Oil Level
To avoid engine damage, it is important to:
• Check oil level before each use and every 5
operating hours when engine is warm. Check oil
level more frequently during engine break-in.
• Keep oil level between “FULL” and “ADD” marks on
dipstick. See Figure 6.
• Insure oil fill cap/plug is tightened securely.
NOTES
Do not overfill oil filler. Doing so may result in oil carry-over
to the air cleaner and equipment malfunction or damage.
Do not allow oil level to fall below the “ADD” mark on
dipstick. Doing so may result in equipment malfunction or
damage.
Contact your Authorized Tecumseh Servicing Dealer for
Tecumseh Oil.
B. Filling Oil Sump
1. Be sure engine is upright and level.
2. Unscrew oil fill cap from oil filler tube and wipe dipstick
clean. See Figure 7.
3. Screw oil fill cap back into oil filler tube. Tighten
securely.
4. Unscrew and remove oil fill cap from oil filler tube. Note
oil level. If oil reading on dipstick is below “ADD” mark,
slowly add oil to reach “FULL” level. See Figure 6.
5. Screw oil fill cap back into oil filler tube. Tighten
securely.
6. Wipe away any spilled oil.
Table 2. Recommended Fuel
Fuel Component Percentage
Ethanol 10%
Grain Alcohol (“Gasohol”) 10%
MTBE (Methyl Tertiary Butyl Ether) 15%
ETBE (Ethyl Tertiary Butyl Ether) 15%
Figure 6. Engine Oil Level
FULL
ADD
OK
Fill between “Full”
and “ADD” Marks
To Next Page
Loading...
Need help?
General
