MAINTENANCE INSTRUCTIONS TEEJET TECHNOLOGIES
98-01580-EN-R0_A4LT-E-ChemSaver-MaintenanceInstructions-TB.docx
The e-ChemSaver Doesn’t Open
During the spray, some nozzles remain closed not working. Probable causes and solutions.
Issue/Problem Solution Example
Blocked, dirty or stuck nozzle Clean the nozzle with water.
Damaged electrical
connector
Change the coil (Reference
CP115881-12).
Broken or defective coil,
pulse is not heard or
detected
Change the coil (Reference
CP115881-12).
Stuck e-ChemSaver
Disassemble the e-ChemSaver and
clean all the holes with clean water.
Spray pressure over max
working pressure
Lower the working pressure, the e-
ChemSaver doesn’t admit pressures
higher than 7 bar / 100 psi.
To Next Page
Loading...