TEFAL FV8066 - Preparation; Filling the Water Tank; Use; Adjusting the Temperature and Steam

6
7
PREPARATION
Filling the water tank
What water to use?
Your iron has been designed to use untreated tap water.
However, the self-clean function must be performed
regularly on the steam chamber to remove limescale.
If your water is very hard, mix 50% untreated tap water
and 50% distilled water.
• Do not use pure demineralised or pure distilled
water, water from clothes dryers, scented or softened
water, or water containing additives (starch,
perfume, aromatic substances, softeners, etc.), rain
water, filtered, bottled or boiled water, water from
refrigerators, batteries or air conditioners. These types
of water contain organic waste, mineral elements
that become concentrated when heated and cause
spitting, brown staining, leaking or premature wear
on your iron.
Warning ! Do not fill your iron through the scale
collector opening. Do not remove the anti-calc
collector to fill the tank.*
USE
Adjusting the temperature and steam
• Set the steam control to
• Adjust the temperature control, referring to the table
below.
• The temperature indicator light turns on.
• It will turn off automatically once the soleplate
achieves the desired temperature.
FABRIC
TEMPERATURE CONTROL
POSITION
LINEN / COTTON
Max
ECO
ECO
WOOL
••
SILK
•
SYNTHETIC
(Polyester, Acetate, Acrylic,
Polyamide)
•
• Plug in the appliance.
Set the temperature control dial to match the type of
fabric you wish to iron. Your iron automatically and
accurately determines the exact steam ow that is
suitable, in order to guarantee the best results.
= STEAM ZONE
*
*
OK
*
Max.
*Depending on model *Depending on model
• Always place your iron on a flat, stable, heat resistant
surface
• Unplug the iron before filling it with untreated tap
water only
• Set the steam control to.
• Lift the iron and, holding it at a slight incline, point
the soleplate up.
• Open the water tank cover.
• Fill the water tank to the mark “Max”.
• Close the water tank cover.