Why is water dripping from my TEFAL Pro Express Protect GV92's soleplate?
If water is dripping from the holes in the soleplate of your TEFAL Iron, it could be due to condensation in the tubes from infrequent use. To resolve this, press the steam button away from your ironing board until the iron emits steam. Alternatively, the soleplate might not be hot enough. Ensure the iron is set to the steam zone as indicated in the user manual.
What to do if white streaks are dripping from my TEFAL Pro Express Protect GV92 Iron?
If you notice white streaks dripping from the holes in the soleplate of your TEFAL Iron, it's likely due to limescale buildup in the boiler from infrequent rinsing. You should rinse the boiler as instructed in the user manual.
Why does my TEFAL Iron leave water spots on my clothes?
If traces of water appear on your laundry while using your TEFAL Iron, the ironing board cover might be saturated because it's not suitable for the steam generator's power. Make sure you use a mesh ironing board to prevent condensation.
Please read these instructions carefully before first use. This product has been designed for domestic and indoor use only.
Pro Express Protect is equipped with a lock system to hold the iron onto the base for easy transport and storage.
Fill in the water tank before every use or when the << water tank empty >> light flashes.
Your steam generator is equipped with a lock system to hold the iron onto the base for easy transport and storage.
Press the « MODE » button located on the control panel to go from one setting to another.
As steam is very hot: never attempt to remove creases from a garment while it is being worn, always hang garments on a coat hanger.
The steam generator is fitted with an «AUTO-OFF» monitoring system, which is activated automatically after approximately 8 minutes without use.
An orange «anti-calc» light located on the control panel starts flashing to inform that the scale collector needs rinsing.
In addition to this regular maintenance, it is advisable to rinse the boiler tank out completely every 6 months or after approximately 25 uses.
Appliance has to be unplugged for at least 2 hours and be completely cool before being carried out.
Switch off and unplug the appliance. Store the power cord in its slide storage place.
General| Power | 2600 W |
|---|---|
| Vertical Steam | Yes |
| Anti-Scale System | Yes |
| Type | Steam Generator Iron |
| Auto Shut-Off | Yes |
| Self-Cleaning | Yes |
| Anti-Calc System | Yes |
| Soleplate | Durilium |
To Next Page