EasyManua.ls Logo

TEFAL Pro Express Ultimate - System Features and Storage; Auto-Off System and Reactivation; Storing the Steam Generator; Environmental Protection

TEFAL Pro Express Ultimate
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
• Check that the steam generator is cold and has been unplugged for at least 2 hours.
• Place the steam generator on the edge of your sink and stand the iron upright.
• Remove the collector cap and unscrew the Anti-calc collector and remove it from the base unit.
• Hold your steam generator in an inclined position. Use a jug to fill the boiler tank with 1/4 litre of untreated tap
water.
Shake the base unit gently for a few seconds and then empty it completely into the sink.
• Place the collector in its housing by screwing it in completely to ensure it is watertight.
• Put the tab back in place.
Next time you use your appliance, press the «OK» button located below the control panel until the orange
«Anti-Calc» light goes out.
«AUTO-OFF» System
For your safety, the steam generator is fitted with an «AUTO-OFF» monitoring system, which is activated automatically
after approximately 8 minutes without use.
• Only the «ON-OFF» button flashes to indicate that the appliance is on standby.
• To reactivate the steam generator:
- Press the «ON-OFF» button.
- Wait for the «ON-OFF» button light to stop flashing before starting your ironing again.
For your safety, after approximately 30 minutes of non-use, the «AUTO-OFF» system switches off your steam
generator. To start your ironing again, press the «ON-OFF» button.
Storing the steam generator
• Place the iron on the steam generator iron rest.
• Switch your steam generator off by pressing the «ON-OFF» button and unplug the appliance.
• Raise the locking system over the iron until the protection system locks into place (audible click)
• Store the steam cord in its slide storage place. Take it, fold it in two so as to make a loop. Put the end of this loop in the
sliding storage then push gently until you see the end on the other side of the sliding storage
• Press the power cord storage button - to store the power cord in its housing. (depending on model)
• Leave the steam generator to cool before putting it away if you are storing it in a cupboard or a confined space.
• If you store your steam generator in a relatively cold place (approximately <10C°), put it in a warm place before
starting your ironing.
• You can store your steam generator safely by carrying it by the iron handle
Environment protection first!
i Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.

Related product manuals