SET Command
You use the SET command to set the value of system variables. A list of all available variables
are provided in Table 4.4. The command has the following format:
SET {VARIABLE NAME} CV {VALUE}
For example, to set the calibration factor to 0.95, issue the command:
SET K_1 CV 0.9500
If the command was successful, the 1830A will return the string:
00:0.9500
VARIABLE LIST Command
This command displays a list of all of the 1830A system variables.
VARIABLE CONFIG Command
This command displays a list of all static system variables and their current values. It returns a
string that can be used to back up the system.
To Next Page
Loading...
