How to troubleshoot a Teka ECO-Cube Fan system that does not start?
If the Teka Fan system doesn't start, first ensure the main switch (pos. 14) is in the ON position. Then, check the power supply plug to make sure it's correctly inserted. Finally, verify that there is power at the outlet and address any mains errors.
Why is the suction power too low on my Teka ECO-Cube Fan?
If the suction power of your Teka Fan is too low, and smoke is hardly extracted, several issues could be the cause. Check if the filter elements are saturated and connect compressed air. Inspect the capturing elements for any damage and replace them if necessary. Ensure the clean air outlet and suction line are not contracted; fix any errors found. Also, verify that the throttle valve in the detection element extraction hood is open.
What to do if there is dust at the dust collector of my Teka ECO-Cube?
If you notice dust at the dust collector of your Teka Fan, it could be due to several reasons. First, the dust collection container might be too full, so empty it. Ensure that the toggle closures are securely closed. Check the seal of the dust collection container for any damage and renew it if necessary. Also, the compressed air for dedusting might be set too high; reduce it accordingly.
Why is my Teka Fan so noisy?
If your Teka Fan unit is very noisy, several factors could be responsible. Ensure the curved silencer (pos. 10) is properly mounted. Verify that the intake and exhaust air pipes are correctly mounted. Check the filter unit for any untight areas.
What causes dust at the service door of a Teka Fan?
If you find dust at the service door of your Teka Fan, make sure all door levers are closed. Inspect the seal between the service door and filter housing for damage and replace it if needed. Reduce the compressed air if it's set too high. Also, check the hinge; it may need reorientation or replacement.
Addresses fire risks and outlines necessary immediate actions and preventative measures.
Detailed instructions for assembling and installing the ECO-Cube filter system on-site.
Instructions for safely connecting the filter system to the electrical power supply.
Procedure for connecting the compressed air for the automatic cleaning function.
Detailed steps for replacing used filter cartridges with new ones.
Testing electrical lines and earthing connections for safety and proper function.
General| Type | Tower Fan |
|---|---|
| Oscillation | Yes |
| Number of speeds | 3 |
| Remote control | Yes |
| Power | 45 W |
| Timer | Yes |
To Next Page
