Teka HKL-840

18
Caution
The electronic clock features Touch-Control
technology. To operate, simply touch the glass
control symbols with your fingertip.
The touch control sensitivity continuously
adapts to ambient conditions. Make sure the
glass surface of the control panel is clean and
free of obstacles when plugging in the oven.
If the clock does not respond correctly when
you touch the glass, unplug the oven for a few
seconds and then plug it in again. Doing this
causes the sensors to adjust automatically so
that they will react once more to fingertip con-
trol.
Electronic Clock Settings
Symbol : lights up during the TEKA
Hydroclean® function.
Symbol : lights up when the clock timer
is selected.
Symbol : lights up to indicate that the
oven is programmed.
Symbol : indicates that the oven is trans-
mitting heat to the food.
+ / – Sensors : enable you to select a time.
Sensors , and : enable you to
programme the electronic clock functions.
Setting the Time
• When you turn on the oven, you will see the
clock flashing 12:00.
• Set the clock by touching the + or – sensor.
You will hear 2 beeps confirming that the
time has been set.
• To change the time, press the + and – sen-
sors at the same time. The current time will
then flash on the screen. Change the time
by pressing the + or – sensors. Two beeps
will then confirm that the new time has
been set.
NOTE
The clock light has a night mode so the dis-
play light will dim between 00:00 and 6:00
hours.
Defrosting
This function uses a two-level hot air system.
LO is for fish, cakes, pastries and bread. HI
(higher temperature inside the oven) is for
meats in general.
TEKA HYDROCLEAN
®
Cleaning func-
tion
After using this cleaning cycle, any traces of
grease or dirt that were stuck to the walls of
the oven can easily be wiped clean with a
damp cloth.
Note
The light remains on when performing any
cook-ing function, except when cleaning.
Using the Oven