27
ENGLISH
CANCELLING THE PYROLYTIC CYCLE
Pyrolysis is an automatic function and therefo-
re can only be activated from the timer pro-
gramme. To cancel a cleaning cycle it is neces-
sary to reset the oven, following the instruc-
tions below:
1 Set the control dial to position and wait
for 1 minute.
2 Unlock the oven door.
1 Set the control dial to position . The
oven will no longer heat up. Wait a few
minutes before continuing with the instruc-
tions to unlock the door.
2 Unlock the oven door. To cancel the clea-
ning cycle, the oven door must be unloc-
ked. To do so, consider the following:
a) Unlocking the door 45 minutes after
the cleaning cycle. If the oven has been
operating for more than 45 minutes, the
door will unlock automatically once the
oven has cooled down to the safe tem-
perature. Then, pilot light will switch
off.
b) Unlocking the door in the first 45 minu-
tes (at a low temperature). Within the
first 45 minutes the oven door will
unlock automatically. Follow the instruc-
tions below:
1 Turn the control dial to position .
2 Wait for approximately 1 minute.
3 Turn the control dial to position .
4 Approximately, 1 minute later pilot
light will turn off and the oven door
can be opened.
To Next Page
Loading...
