29
User’s Guide
English
IMPORTANT
This function can only be selected when the
oven command functions are set to the rest
position
.
0ODF UIF EPPS IBT CFFO MPDLFE ZPV DBO
start cooking normally.
To activate/deactivate the door lock, follow
these steps:
1. Touch
or until the symbol on the
display starts flashing.
The current door lock status will be dis-
QMBZFEi0OwJGJUJTBDUJWFBOEi0GGwJGEFBDUJ-
vated.
2. Press . You will then hear a beep and the
CMPDLXJMMTUBSUUPBDUJWBUFJGJUXBTi0GGwPS
EFBDUJWBUFJGJUXBTi0Ow
WARNING
Before locking, ensure that the oven door is
properly closed. If not, it will not lock and an
alarm will sound.
If this happens, switch off the alarm by
pressing any clock button, close the door
properly and lock again as per the instruc-
tions above.
3. 0ODF UIF EPPS IBT CFFO GVMMZ MPDLFEVO-
locked, the display will show the new door
status.
In the event that the locking system is active,
the
symbol will appear constantly lit on
the display.
IMPORTANT
To unlock the door during cooking, turn the
function dial to standby and unlock the door
as described above.
0ODFUIFEPPSJTVOMPDLFEUVSOUIFGVODUJPO
dial back to its former position to continue
cooking.
Teka Hydroclean
®
function
This function makes it easy to remove grease
and other food debris that may have stuck to
the sides of the oven.
For easier cleaning, do not allow dirt to accu-
mulate. Clean the oven frequently.
PROGRAMMING THE TEKA
HYDROCLEAN® FUNCTION
®
WARNING
Do not pour water into a hot oven as this can
damage the enamel of the oven.
Always run the cycle on a cold oven. The result
could be affected and the varnish damaged if it
is run when the oven is too hot.
First remove the trays and all accessories from
the oven interior, including the tray supports and
telescopic guide rails. To do this, follow the
instructions in the installation and mainte-
nance guide accompanying the oven.
1. With the oven cold, spread a cloth out on the
bottom of the oven.