Teka MS 620 BIS - Service, Repair, and Damage Prevention; Service and Repair

8
 Please follow the instructions regarding cleaning in the
section "Oven Cleaning and Maintenance".
 WARNING: Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of electric shock.
Please refer to the chapter "CHANGING THE OVEN LIGHT
BULB".
Service and Repair
 WARNING! Cut the power supply before repair.
 WARNING! Only a competent person can carry out any
service or repair operation that involves the removal of a
cover which gives protection against exposure to
microwave energy.
 WARNING! If the door or door seals are damaged, the
appliance must not be operated until it has been repaired
by a competent person.
 If the power cable is damaged it should be substituted by
the manufacturer, authorized agents or technicians
qualified for this task in order to avoid dangerous situations.
 Repair and maintenance work, especially of current
carrying parts, can only be carried out by technicians
authorized by the manufacturer.
Avoid damaging the oven or other dangerous situations by
following these instructions
 Never switch on the microwave when it is empty. If there is
no food inside there may be an electrical overcharge and
the oven could be damaged. RISK OF DAMAGE!
 For carrying out oven programming tests put a glass of
water inside the oven. The water will absorb the
microwaves and the oven will not be damaged.
 Do not cover or obstruct the ventilation openings.