Installation Instructions
Remove the microwave oven from packing.
Remove all packing materials and accessories from the microwave oven cavity.
Check whether the following parts are in good condition:
- Door and hinges;
- Front of the microwave oven;
- Inside and outside of microwave oven.
Should you find any faults DO NOT USE THE MICROWAVE OVEN, and contact your dealer.
Place the microwave oven on a flat stable surface able to support its weight.
To allow efficient cooling of the microwave oven its installation is recommended in a unit with an
opening in the upper part (refer to the installation instructions leaflet enclosed).
Warning: The microwave oven plug shall be accessible after installation.
When installing the microwave oven great care should be taken to ensure that the mains power cable
cannot come into contact with the rear since the high temperatures involved could cause damage.
When the microwave oven is installed in a column with a conventional oven, the microwave oven must
not be located underneath the conventional oven because of the possibility of condensation forming
inside the latter.
The microwave oven has been supplied with a mono-phase power supply cord. The appliance must be
earthed.
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturers and dealers are not liable for any breakdowns or personal accidents should these
installation instructions not be observed by the purchaser.
To Next Page
Loading...
Need help?
General
