Tekmar 1773 - Page 12

- 12 -
Direct functions
Manual activation/deactivation of the slab heating
From the home display the heating can be activated by pressing the"+" pushbutton for a least two seconds. The
heating duration corresponds to the minimum heating time. If the heating has already been active, the remaining
heating time will be reset to the minimum heating time.
By pressing the "-" pushbutton from the home display, the heating is switched off, no matter if the heating has
been switched on manually or automatically.
If the device is in the "Off" mode, the "+" and "-" pushbuttons have no effect.
Menu structure
ESC function: If you press the "+" and "–" pushbuttons at the same time, you will go back to the previous
menu from any menu or to the home display from the main menu.
Initial commissioning
Menu level 1
Explanation
Language --
Presetting of menu language
Operation
Home display
Menu level 1
Menu level 2
Menu level 3
Explanation
...°c 0
Active
Slab temperature, Remaining
heating time, Operating state
Basic
Config.
Language
Setting: language version
Sensor n
Typ
Setting: sensor type
Temp Hi
Lim. ..°c
Setting: high temperature limit
HeatTime
min. ...m
Setting: minimum heating time
back
Show
status
State
-----------
Display: operating mode ice and
snow detector
Error
Code x
Display: error code ice and snow
detector
Slab
Heating
Slab
Heat.
Display: heating on/off
Time Mtr
1: .h
Display: counter level operating
hours
Time Mtr
2: .h
Display: counter level operating
hours
Reset
Mtr1
Command: delete counter level 1
RemHeat
Tim ...m
Display: remaining heating time
Slab
T ...°c
Display: slab temperature
Outdoor
T---x-°c
Display: outdoor temperature
Status
Sensor
State S.
-----------
Display: operating mode sensor
Error
Code
Display: error code sensor
Sensor
T. ...°c
Display: sensor temperature
Ambient
T. ...°c
Display: ambient temperature