To Next PageTo Next Page
Need help?Do you have a question about the Tekmar Boiler Control 263 and is the answer not in the manual?
Explains how to navigate the control's menus and buttons for setup and monitoring.
Details the LCD fields, buttons, and operational symbols of the control.
Covers control operating modes, types of demands, and powering up.
Details boiler target temperature, staging, modulation, and differential settings.
Explains setback, exercising, running times, and factory defaults for the control.
Describes primary pump operation, purge cycles, and boiler pump functions.
Explains how the control adjusts supply water temperature based on outdoor air and terminal units.
Covers DHW demand sources, priority modes, and operation with various tank piping.
Details how the control manages setpoint loads, priority, and parallel/primary modes.
Covers preparation, base mounting, and rough-in wiring for control installation.
Details power inputs, output terminals, modulation outputs, and sensor connections.
Explains the configuration options available through the control's DIP switches.
Details the parameters and data available for viewing on the control's display.
Comprehensive list of adjustable settings for mode, temperature, timing, and schedules.
Instructions for setting the internal clock and programming daily occupied/unoccupied schedules.
Outlines the built-in test routine for checking control functions and sequences.
Lists common error codes, their causes, and the Max Heat operational mode.
Provides device specifications, approvals, and limited warranty information.
Explains how to navigate the control's menus and buttons for setup and monitoring.
Details the LCD fields, buttons, and operational symbols of the control.
Covers control operating modes, types of demands, and powering up.
Details boiler target temperature, staging, modulation, and differential settings.
Explains setback, exercising, running times, and factory defaults for the control.
Describes primary pump operation, purge cycles, and boiler pump functions.
Explains how the control adjusts supply water temperature based on outdoor air and terminal units.
Covers DHW demand sources, priority modes, and operation with various tank piping.
Details how the control manages setpoint loads, priority, and parallel/primary modes.
Covers preparation, base mounting, and rough-in wiring for control installation.
Details power inputs, output terminals, modulation outputs, and sensor connections.
Explains the configuration options available through the control's DIP switches.
Details the parameters and data available for viewing on the control's display.
Comprehensive list of adjustable settings for mode, temperature, timing, and schedules.
Instructions for setting the internal clock and programming daily occupied/unoccupied schedules.
Outlines the built-in test routine for checking control functions and sequences.
Lists common error codes, their causes, and the Max Heat operational mode.
Provides device specifications, approvals, and limited warranty information.
General| Application | Boiler Control |
|---|---|
| Domestic Hot Water | Yes |
| Outdoor Reset | Yes |
| DHW Priority | Yes |
| Supply Voltage | 24 VAC |
| Control Type | On/Off |
| Differential | Adjustable |
| Voltage Rating | 24 VAC |
| Enclosure Rating | NEMA 1 |
| Input Type | Thermistor |
