118-0417-011 17
CLEANING THE VERSATURN™ GRINDING WHEEL
• The Grinding Wheel should only be cleaned after the power cord is removed from the power
source and the Power Switch is turned to “OFF.” Clean any dust buildup from around moving
parts. Use a clean rag, brush, or compressed air source to remove excessive dust buildup.
• NEVER use flammable materials to clean the grinder.
• NO LUBRICATION is required. The VERSATURN™ Grinding Wheel uses sealed lubrication
bearings installed at the factory.
ACCESSORIES:
Optional accessories for the VERSATURN™ Grinding Wheel can include wire-brush wheels
that can be used for cleaning and layered cloth wheels that can be used for polishing and
buffing. Contact the NOVA Customer Service Center (1-866-748-3025 Toll Free) or your
nearest NOVA dealer to find where our accessories are available.
WARNING Only use accessories that are designed to fit your VERSATURN™ Grinding
Wheel. These accessories should be specifically labeled to match the speed and arbor size of
the grinder. Failure to use the proper accessories could result in property damage, damage to
the grinder, and serious personal injury to the operator.
Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets. If the grinder
must be used outside, use an extension cord labeled “W-A” or “W.” These extension cords are
rated for outdoor use and reduce the chances of electrical shock.
If you must use an extension cord, be sure that the gauge is large enough to carry the amount
of current necessary for your power tool. If not, your tool may experience a loss of power,
excessive voltage drop or overheating. The smaller the gauge number, the heavier the cord.
To Next Page
Loading...