10. WHEN NOT IN USE, SECURE THE ELECTRICAL POWER CORD BY REMOVING IT
FROM THE WALL OUTLET to prevent unauthorized use of the NOVA Comet II Midi
Lathe and NOVA VERSATURN™ Grinder Accessory Attachment. Doing so will prevent
children or unauthorized personnel from accidentally turning it “ON.”
11. DO NOT STAND DIRECTLY IN FRONT OF THE NOVA VERSATURN™ GRINDER
ACCESSORY ATTACHMENT when it is first turned on. Loose fragments could fly off the
grinding wheel or wire brush at high speeds possibly causing serious injuries.
12. NEVER ENGAGE A WORK PIECE TO A COLD GRINDING STONE. A cold grinding
stone has a tendency to chip. Allow the NOVA VERSATURN™ GRINDER ACCESSORY
ATTACHMENT to run for an entire minute before applying the work piece to the grinding
stone.
13. THOROUGHLY CLEAN THE NOVA VERSATURN™ GRINDER ACCESSORY
ATTACHMENT WHEEL BEFORE CHANGING TYPES OF WORK PIECES. Combining
wood and metal dust can result in an explosion or fire. DO NOT GRIND OR POLISH
WORK PIECES MADE OF MAGNESIUM. The magnesium could ignite resulting in a
very intense fire that could cause severe injury/burns to the operator and/or seriously
cause grinder or property damage.
14. NEVER PERFORM GRINDING OPERATIONS NEAR FLAMMABLE GASES,
MATERIALS OR LIQUIDS. The resulting fire and/or explosion could cause permanent
serious injuries to the operator and damage to the grinder and surrounding work area.
15. AVOID AWKWARD POSITIONS for both hands and work pieces. A sudden slip could
draw fingers into the grinding wheel. ALWAYS KEEP ARMS, HANDS AND FINGERS
away from the grinding wheel surface or serious injuries could result.
16. HOLD THE WORK PIECE FIRMLY AGAINST THE NOVA VERSATURN™ GRINDER
ACCESSORY ATTACHMENT WHEEL. A loose grip can cause loss of control of the
work piece resulting in severe injuries or damage to the bench grinder.
17. ALWAYS MAKE CONTACT WITH THE FACE OF THE GRINDING STONE. Grinding
objects on the side of the grinding stone can cause the stone to fragment resulting in
fragments being thrown from the wheel at high speeds possibly causing serious injuries
18. NEVER APPLY A COOLANT DIRECTLY TO THE WORK PIECE WHILE IT IS IN
CONTACT WITH THE GRINDING STONE. Coolant can weaken the material of the
grinding stone causing it to fail and possibly causing serious injuries. Dip the work piece
in water to cool it.
19. DO NOT TOUCH THE JUST GROUND PORTION OF THE WORKPIECE until it has
properly cooled. Touching HOT surfaces can result in serious injuries.
To Next Page
Loading...