Teknion District Series

To Next Page

Part and Product Identification

Section:

Description:

Page No:

Date:

Rev. No: 2

Dec 2015 1 of 5

DIS_102b_G01

district

Convertible Panel Wall with Accessory Beam (UAFCR) &

Convertible Panel Wall Base and Foot Trim (UNPCF)

For Customer Support please contact

product.support@teknion.com

A - Convertible Panel Frame Assembly

(N02-1553) 24"-60"x1 66"-96"x2

UAFCR

UNPCF

B1 - Hex Flange Locking Bolt

5/16-18x3.5-in Long Plate

(E03-0430) x1

B2 - Flat Washer

(E03-0457) x2

B3 - 5/16-18 Lock Nut Zinc Plate

(E03-0437) x1

C1 - Center Rail Extrusion Cap

(A23-4058) x1

C2 - Center Rail

(A23-4840) x1

C3 - 5/16-18x2 Hex Cap Screw Grade 2

(A23-4840)

24"-35"x2 36"-60"x4 62"-96"x6

C4 - Flat Washer

(E03-0457)

24"-35"x2 36"-60"x4 62"-96"x6

C5 - 5/16-18x2 Lock Nut Zinc Plate

(E03-0437)

24"-35"x2 36"-60"x4 62"-96"x6

D1 - Base Trim

(A15-8542) 24"-60"x1 62"-96"x2

D2 - Elevated Foot

(A15-8546) 24"-60"x2 62"-96"x4

D3 - #12x1"Long, Type AB, Truss Head,

Tapping Screw, Black

(E07-0050) 24"-60"x3 62"-96"x6

B - (X01-1747)

24"-60"x3

66"-96"x6

C - (N02-2834) 24"-60"x1 66"-96"x2

NOTE: 72" Convertible Panel Wall with

Accessory Beam (UAFCR) & Convertible

Panel Wall Base and Foot Trim (UNPCF)

shown as an example

Need help?

Do you have a question about the Teknion District Series and is the answer not in the manual?

Summary

Convertible Panel Wall System

Part and Product Identification

Lists and identifies all components for the Convertible Panel Wall, Accessory Beam, Base, and Foot Trim.

Base Trim and Elevated Feet Installation

Install Base Trim

Secures the Base Trim to the lower horizontal tube of the Convertible Panel Frame.

Elevated Feet Installation

Attaches Elevated Feet to the outside edge of the vertical tube of the panel frame.

Frame and Beam Assembly

Frames Assembly

Aligns and secures two panel frames together using bolts, washers, and nuts.

Insert Bolts for Accessory Beam

Inserts bolts into the channel on the bottom side of the Accessory Beam.

Accessory Beam Assembly

Attaches Accessory Beams to the panel frames and secures them with washers and nuts.

Final Panel Setup

Level Convertible Panel Wall

Levels the assembled Convertible Panel Wall and adjusts levelers as necessary.

Insert Extrusion Cap

Inserts the extrusion cap into the Accessory Beam.