Compliance Information
1
This product is intended for use in nonresidential areas only. Use in residential areas
may cause electromagnetic interference.
2
Emissions which exceed the levels required by this standard may occur when this
equipment is connected to a test object.
3
To ensure compliance with the EMC standards listed here, high quality shielded interface
cables should be used.
4
Performance Criterion C applied at the 70%/25 cycle Voltage-Dip and the 0 %/250 cycle
Voltage-Interruption test levels (IEC 61000-4-11).
Australia / New Zealand Declaration of Conformity – EMC
Complies with the EMC provision of the Radiocomm unicatio ns Act
per the following standard::
CISPR 11:2003. Radiated and Conducted Emissions, Group
1, Class A, in accordance with EN 61326-1:2006 and
EN 61326-2-1:2006.
Safety Compliance
Pollution Degree Description
A measure of the contaminants that could occur in the environment
around and within a product. Typically the interna l environment inside
a product is considered to be the same as the external. Products should
be used only in the environment for which they are rated.
Pollution D egree 1. No pollution or only dry, nonconductive
pollution occurs. Products in this category are generally
encapsulated, hermetically sealed, or located in clean rooms.
Pollution Degree 2. Normally o n ly dry, nonconductive pollution
occurs. Occasionally a temporary conductivity that is caused
by condensation must be expected. This location is a typical
office/home environment. Temporary condensation occurs only
when the product is out of service.
Pollution Degree 3. Conductive pollution, or dry, nonconductive
pollution that becomes conductive d ue to condensation. These
are sheltered locations where neither temperature nor humidity
is controlled. The area is protected fro m direct sunshine, rain, or
direct wind.
vi 1103 Po wer Sup ply Instruction Manual
To Next Page
Loading...
Need help?
General
