Tektronix DPO2000 Series - Page 136

Commands Listed in Alphabetical Order
CURSor:XY:PO
Lar:THETA:DELta? (Query Only)
Returns the XY cursor polar angle delta.
Group
Cursor
Syntax
CURSor:XY:POLar:THETA:DEL ta?
CURSor:XY:POLar:THETA:POSITION<x>? (Query Only)
Returns the cursor X or cursor Y polar coordinate, where x is either 1 or 2.
Group
Cursor
Syntax
CURSor:XY:POLar:THETA:POS ITION<x>?
CURSor:XY:POLar:
THETA:UNIts? (Query Only)
Returns the cursor coordinate units.
Group
Cursor
Syntax
CURSor:XY:POLar:THETA:UNI ts?
CURSor:XY:PRODUCT:DELta? (Query Only)
Returns the difference between the cursors X position and cursor Y position. The
ΔX×ΔY value is calculated as (X2 – X1) × (Y2 – Y1).
Group
Cursor
Syntax
CURSor:XY:PRODUCT:DELta?
2-120 MSO2000B, DPO2000B, M SO2000 and DPO2000 Series Oscilloscopes Programmer Manual