Commands Listed in Alphabetical Order
start acquisit
ions again, it will continue from 5000. The number will reset to 0
only if you change the horizontal scale while acquisitions are running.
Group
Acquisition
Syntax
ACQuire:NUMACq?
Related Commands
ACQuire:STATE
Returns
ACQuire:NUMACq? might return :ACQUIRE:NUMACQ 350 indicating that 350
acquisitions have occurred.
ACQuire:NUMAVg
Sets or returns the number of waveform acquisitio
ns that make up an averaged
waveform. Use the ACQuire:MODe command to enable the Average mode.
Sending this command is equivalent to turning a multipurpose knob to enter the
number of waveform acquisitions to average.
Group
Acquisition
Syntax
ACQuire:NUMAVg <NR1>
ACQuire:NUMAVg?
Related Commands
ACQuire:MODe
Arguments
<NR1> is the number of waveform a cquisitions to average. The range of values is
from2to512inpowersoftwo.
Examples
ACQUIRE:NUMAVG 16 specifies that 16 waveform averages will be performed
before exponential averaging starts.
ACQUIRE:NUMAVG? might return :ACQUIRE:NUMAVG 64 indicating that there
are 64 acquisitions specified for a veraging.
ACQuire:STATE
Starts or stops acquisitions. When state is set
to ON or RUN, a new acquisition
will be started. If the last acquisition was a single acquisition sequence, a new
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-61
To Next Page
Loading...
Need help?
General
