Tektronix DPO2012 Programmer's Manual

Command Groups
Table 2-31: Trigger Commands (cont.)
Command
Description
TRIGger:A:BUS:B <x >:SPI:D ATa{:OUT|:M OSI}:VALue Sets or returns the binary
datastringusedfortheSPI
trigger
TRIGger:A:BUS:B <x>:SPI:DATa:SIZe Sets or returns the length of
thedatastringinbytestobe
used for SPI trigger
TRIGger:A:BUS:S OUrce Sets or returns the source
for a bus trigger
TRIGger:A:EDG E?
Returns the source, coupling
and source for the A edge
trigger
TRIGger:A:EDGE:COUPling Sets or returns the type
of coupling for the A edge
trigger
TRIGger:A:EDGE:SLOpe Sets or returns the slope for
the A edge trigger
TRIGger:A:EDGE:SOUrce Sets or returns the source
for the A edge trigger
TRIGger:A:HOLDoff? Returns the A trigger holdoff
parameters
TRIGger:A:HOLDoff:TIMe Sets or r eturns the A trigger
holdoff time
TRIGger:A:LEVel Sets or returns the trigger
level for the A trigger
TRIGger:A:LEVel:AUXin Sets or returns the trigger
level for the AUXIN port
TRIGger:A:LEVel:CH<x> Specifies or returns the
trigger level for the specified
trigger channel
TRIGger:A:LEVel:D<x> Sets or returns the trigger
level for the specified digital
channel <x>, where x is the
channel number
TRIGger:A:LOGIc?
Returns all A trigger logic
settings
TRIGger:A:LOGIc:CLAss Sets or returns the type of A
trigger logic
TRIGger:A:LOGIc:F U NCtion Sets or returns the logical
combination of the input
channels for the A logic
trigger
TRIGger:A:LOGIc:IN Put?
Returns the logic input
values for all channels
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-43

Tektronix DPO2012 Specifications

General

Brand	Tektronix
Model	DPO2012
Category	Test Equipment
Language	English