Tektronix DPO2024 Programmer's Manual

Commands Listed in Alphabetical Order
Examples
CH1:PROBE:ID:
SERNUMBER?
might return :CH1:PROBE:ID:SERNUMBER
"B010289"
indicating that the serial number of the probe attached to channel 1
is B010289.
CH<x>:PRObe
:ID:TYPE? (Query Only)
Returns the type of probe attached to the channel specified by <x>, where x
is the channel number. Level 2 (or higher) probes supply their exact product
nomenclat
ure; for Level 0 or 1 probes, a generic “No Probe Detected message is
returned.
Group
Vertical
Syntax
CH<x>:PRObe:ID:TYPE?
Examples
CH1:PROBE:ID:TYPE? migh
treturn
:CH1:PROBE:ID:TYPE "P6203"
indicating that P6203-type probe is attached to channel 1.
CH<x>:PRObe:RESistance? (Query Only)
Returns the resistance factor of the probe attached to channel < x>, where x is the
channel number.
Group
Vertical
Syntax
CH<x>:PRObe:RESistance?
Examples
CH2:PRObe:RESistance? might return :CH2:PROBE:RESISTANCE
10.0000E+6
indicating that the input resistance of the probe attached to Channel
2is1MΩ.
NOTE. This query will return 0.0 if n
o probe is attached or the attached probe
does not report the input resistance.
CH<x>:PRObe:SIGnal
Sets or returns the input bypass setting of a TekVPI probe attached to channel
<x>, where x is the channel number. The probe must support input bypass, for
example TCP0001. This command i
s ignored if sent to an unsupported probe.
MSO2000B, DPO2000B, MSO2000 and DPO2000 Series Oscilloscopes Programmer Manual 2-107

Tektronix DPO2024 Specifications

General

Brand	Tektronix
Model	DPO2024
Category	Test Equipment
Language	English