Troubleshooting the Demo Board
If the demo board is still not acting p roperly, the following is a “master” reset procedure that you can try.
1. Push and continue to hold do wn th e On/Off switch in the board’s Single Shot Box.
2. Push an d release the Reset switch.
3. In the Serial Select Box, all four LEDs (RS232, I2C, SPI, and CAN) should no w turn on .
4. When all four LEDs (RS232, I2C, SPI, and CAN) in the Serial Select Box g o out, release the On/Off switch.
5. A momen t later, all four LEDs (RS232, I2C, SPI, and CAN) should flash several times. Then only the I2C LED will be lit.
Tektronix 4000 Oscilloscope Demo In struction Manual 105
To Previous Page
Loading...
Need help?
General
