Compliance Information
European Contact.
Tektronix UK, Ltd.
Western Peninsula
Western Road
Bracknell, RG12 1RF
United Kingdom
1
This product is intended for use in nonresidential areas only. Use in residential areas may cause electromagnetic interference.
2
Emissions which exceed the levels required by this standard may occur when this equipment is connected to a test object.
3
To ensure compliance with the EMC standards listed here, high quality shielded interface cables should be used.
4
Instrument rebooting may be experienced where the EUT takes longer than 10 seconds to recover from a transient immunity test.
5
The increase in trace noise while subjected to the test field (3 V/m over the frequency range 80 MHz to 1 GHz, 1.4 GHz to 2.0 GHz, and
1 V/m from 2.0 GHz to 2.7 GHz, with 80% amplitude modulation at 1 kHz) is not to exceed 8 major division(s) peak-to-peak. Ambient
fields may induce triggering when trigger threshold is offset less than 4 major divisions from ground reference (IEC 61000-4-3).
6
The increase in trace noise while subjected to the injected 3 V test signal is not to exceed 2 major divisions peak-to-peak. Ambient
fields may induce triggering when trigger threshold i s offset less than 1 major division from ground reference (IEC 6 1000-4-6).
7
Performance Criterion C applied at the 70%/25 cycle Voltage-Dip and the 0%/250 cycle Voltage-Interruption test levels
(IEC 61000-4-11).
Australia / New Ze aland Declaratio n of Conformity – E MC
Complies with the EMC provision of the Radiocommunications Act per the following sta ndard, in accordance w ith ACMA:
CISPR 11:2003. Radiated and Conducted Emissions, Group 1, Class A , in accordance with EN 61326-1:2006 and
EN 61326-2-1:2006.
MSO4000 and DPO4000 Series Oscilloscopes User Manual xi
To Next Page
Loading...
Need help?
General
