Performance Verification
13. Repeat the test
sat1MΩ impedance as follows:
a. Push the front-panel channel 1 button.
b. Set the Termination (input impedance) to 1M Ω.
c. Repeat steps 4 through 12.
14. Repeat the procedure for all remaining channels as follows:
a. Deselect the channel that you already tested.
b. Move the 50
Ω terminator to the next channel input to be tested.
c. Starting from step 3, repeat the procedure for each channel.
58 MSO4000B and DPO4000B Series Specifications and Performance Verification
To Next Page
Loading...
