TM 11-6625-2980-14
Power Transformer. Refer to the exploded view
drawing at the rear of the Power Module manuals for
disassembly of the rear panel to expose the power
transformer. Refer to the schematic diagram color-
coding information for correct wiring. After replacement,
check out the power supply voltages before installing a
plug-in module.
REPACKAGING FOR SHIPMENT
Save and re-use the package in which your instrument
was shipped If the original packaging is unfit for use or
not available, repackage the instrument as 'follows:
1. Obtain a carton of corrugated cardboard having
inside dimensions of no less than six inches more
than the instrument dimensions; this will allow for
cushioning. Refer to the following table for carton
test strength requirements.
2. Surround the instrument with polyethylene sheeting
to protect the finish of the instrument.
3. Cushion the instrument on all sides by tightly
packing dunnage or urethane foam between carton
and instrument, allowing three inches on all
sides.
4. Seal carton with shipping tape or industrial stapler.
SHIPPING CARTON TEST STRENGTH
Gross Weight (lb.) Carton Test Strength (lb.)
0-10 200
10-30 275
30-120 375
120-140 500
140-160 600
A-13
To Next Page
Loading...
Need help?
General
