Installation
For informa tion about option activation and operation, refer to the
SignalVu-PC Help, located in the SignalVu-PC application under Help
>User.
Load the API and USB driver software
Load the software using the procedure below.
1. Insert the flash drive included with th e analyzer in to th e host PC.
Windows File Expl orer sho uld op en automatically. If it does not,
open it m a nu ally and browse to the flash d rive folder.
2. Select RSA API and USB from the list of folders.
3. Double-click Setup.exe and follow the on-screen in structions to
install the software.
Make the connections
Refer to the front panel illustratio n for connector locations. (See
Figure 4 on page 11.)
1. After the software has been installed, connect the USB cable
included with the analyzer between the analyzer and the host PC.
2. Connect an RF cable between the RSA input and the signal sou rce.
(See Figure 2.)
8 RSA306B and RSA306B-SMA Installation and Safety Instructions
To Next Page
Loading...
Need help?
General
