Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–99
DIAg:SELect:ACQUISition (No Query Form)
Selects the acquisition system test sequence that will be run when the
DIAg:STATE EXECUte command is sent. This command is equivalent to setting
Area in the Utility menu when System is set to Diag/Err.
Calibration and Diagnostic
selects functional, memory, and register tests.
DIAg:SELect:ALL (No Query Form)
Specifies that all system test sequences will be run when the DIAg:STATE
EXECUte command is sent. This command is equivalent to setting Area in the
Utility menu when System is set to Diag/Err.
Calibration and Diagnostic
selects functional, memory, and register tests for the acquisition, processor
and display systems, and self diagnostics for the front panel.
DIAg:SELect:CPU (No Query Form)
Selects the processor system test sequence that will be run when the
DIAg:STATE EXECUte command is sent. This command is equivalent to setting
Area in the Utility menu when System is set to Diag/Err.
Calibration and Diagnostic
Group
Syntax
Arguments
Group
Syntax
Arguments
Group
Syntax
To Next Page
Loading...
Need help?
General
