Tektronix TDS 410A Programming Manual

Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–251
ACCept
TRIGger :
:
PULse
MAIn :
:
FILTer
GLItch
REJect
<Space>
?
ACCept specifies that the digitizing oscilloscope will trigger only on pulses that
are narrower than the specified width when the main trigger type is set to pulse
glitch. The width is specified using TRIGger:MAIn:PULse:GLItch:WIDth
command.
REJect specifies that the digitizing oscilloscope will trigger only on pulses that
are wider than the specified width when the main trigger type is set to pulse
glitch. The width is specified using TRIGger:MAIn:PULse:GLItch:WIDth
command.
TRIGGER:MAIN:PULSE:GLITCH:FILTER?
returns either ACCept or REJect, indicating whether glitches are filtered.
TRIGger:MAIn:PULse:GLItch:POLarity
TDS 5XXA, 6XXA, & 7XXA Only
Sets or queries the polarity for the main pulse glitch trigger. This command is
equivalent to selecting Polarity & Width in the Trigger menu.
Trigger
TRIGger:MAIn:PULse:GLItch:POLarity { EITher | NEGAtive |
POSITIVe }
TRIGger:MAIn:PULse:GLItch:POLarity?
<Space>
EITher
?
POSITIVe
NEGAtive
TRIGger :
MAIn
POLarity
:
PULse
:
:GLItch
TRIGGER:MAIN:PULSE:GLITCH:POLARITY EITHER
specifies that the polarity of the glitch can be either positive or negative.
Arguments
Examples
Group
Syntax
Examples

Tektronix TDS 410A Specifications

General

Brand	Tektronix
Model	TDS 410A
Category	Test Equipment
Language	English