Program Examples
TDS Family Oscilloscope Programmer Manual
4ā3
īī ī1ī'*&ī-
ī)*2 īī
ī+/#ī%īīīīīī ī
4. For this installation, you will also want to copy īīīīīī and īīīīīīīī from
your Tektronix S3FG210 (National Instruments GPIB-PCII/IIA) GPIB
drivers directory to this directory. For example, if the GPIB drivers are in the
!*#ī3*ī directory and you are in the example programs directory, you
would type:
ī)*2 ī!*#īī*īīīīī&ī" ī
ī)*2 ī!*#īī*īī'ī#īī)ī$ ī
5. To compile and link your TDS sample C programs, simply type: ('ī%ī
ī #&ī (ī'īīī'ī%
where <file name> refers to the name of the example program you wish to
compile and link. Specifically:
To compile and link īīīīīī, type: ('ī%ī 'īī-ī'ī%
To compile and link īīīīīī, type: ('ī%ī ī)''ī'ī%
To compile and link īīīīīīīī, type: ('ī%ī !ī.0 'ī'ī%
To compile and link īīīīīīīī, type: ('ī%ī ī/,-),ī'ī%
To compile and link īīīī, type: ('ī%ī .&ī'ī%
6. Run the program by simply typing the program name.
To run 'īī-, type: 'īī-
To run ī)'', type: ī)''
To run !ī.0 ', type: !ī.0 '
To run ī/,-),, type: ī/,-),
To run .&, type: .&
To make an executable for any of the following files, perform the following:
1. Install QuickBASIC.
2. Install the Tektronix S3FG210 (National Instruments GPIB-PCII/IIA) GPIB
board and drivers. Remember to reboot your PC to initialize the GPIB
drivers.
3. Copy the files from the examples diskette to your hard disk. You might also
create a special directory to store them. For example, if the current drive is
Compiling and Linking
Your Example
QuickBASIC Programs
To Next Page
Loading...
Need help?
General
